Wall Sweeps

[dsw98]

Is it possible to put a wall sweep on an angle to match a roof pitch?

[blads]

Is it possible to put a wall sweep on an angle to match a roof pitch?


Absolutely... use the create sweeps method (Modelling>Create>Sweepand pick your path (eg roof pitch, ref plane, whatever) rather than Modelling>Host Sweep>Wall Sweep...

HTH

[dsw98]

Absolutely... use the create sweeps method (Modelling>Create>Sweepand pick your path (eg roof pitch, ref plane, whatever) rather than Modelling>Host Sweep>Wall Sweep...

HTH


I can't find "sweep" under "create". Are you saying just create a generic model and just add it to the wall? That's a good way of doing it, but takes too much time to do that around an entire house. I wanted to be able to add the wall sweep just like I would a horizontal or vetical wall sweep.

[bowlingbrad]

You can also use the roof edge, facia, or floor edge sweep.

[Rhythmick]

To match the roof pitch you can use the facia sweep tool and set the offset vertical and horizontal parameters in the sweep properties.

Brad,
I have not been able to set a floor edge sweep on the sloped edge of a floor with the Host Sweep tool, am I missing something?

[bowlingbrad]

Mike,
I'm in the middle of a deadline and an upgrade. I'll try to get back to you soon.
Brad