Wall Sweep Issues

[khomburg]

I am having problems with some wall sweeps in the attached image. I am at the point where I can not do anything to the walls without getting the error message:

"Could not create integral wall sweep for wall instance. Failed to cut wall."

The sweeps above the windows and doors were created as a host wall sweep. The sweeps at the top of the walls are part of the wall type. The pilasters are in-place extrusions that are joined to the walls.

If anyone has any suggestions I would appreciate it.

[sbrown]

The sweeps above the windows and doors should be in the window and door family, not wall hosted sweeps. Not sure if that will help your situation, but will make your modeling easier.