Railings

[tect75]

just created a stair. can i place a railing so that it follows the slope of the stair. even when i select the stair as host it still comes out straight. not sloped to the stair. what to do?

[Steve_Stafford]

just created a stair. can i place a railing so that it follows the slope of the stair. even when i select the stair as host it still comes out straight. not sloped to the stair. what to do?You need to make sure the sketch and the offset settings for the railing do not place the railing outside the perirmeter of the stair object. If it does, it "falls" to the ground :wink:. Try moving the sketch over the stair a little to see if it behaves. If so, you just need to tweak the railing offset values and the sketch line positions.