Site Levels

[Exar Kun]

For the first time I've imported a surveyor's ACAD drawing into REvit and used it to create topography. I was wondering if there is an easy way to set the RLs. So I could have, say the FFL at 0 equal to a site elevation of 55000 without having to set the FFL to 55000 and the FCL to 57400 etc (or at least get the computer to work out the levels instead of lazy old me). That sounds a ibt confusing so I hope you get my drift.

Thanks.

:)

[christo4robin]

Exar,

Read help on shared locations and relocating a project.

I believe I have done what you are talking about by relocating a project and then having two different families of levels and spot elevations. Each family can refer to either the project location or the shared location (in my use, civil or architectural). The help file has a good explanation of this.

Cheers!