gwhitehill
2005-11-21, 05:13 PM
Description: Hatching for certain materials in the details component manager acted differently in ADT 2005 than in 2006. For materials such as rigid insulation and plywood in 2005 the snap base was temporarily set to the insertion point of the material. Thus the hatch was always the same IN RELATION TO THE MATERIAL OUTLINE. This is good! In 2006 the hatching snap base is 0,0 (or whatever) so the hatch pattern in relation to the material outline is dependent on where the materila is placed. The 2005 functionality needs to be restored.
How used: Transparent to the user.
Feature Affinity: Consistent hatching material to material
How used: Transparent to the user.
Feature Affinity: Consistent hatching material to material