awarren
2005-11-21, 07:57 PM
I would like to see Sheet Metal Improvements!
Unfold: Better Unfolding of the parts, with more options (also available solid unfold) as with DataM
Corner Reliefs: More relief options for controlling the corner bends. In some situations you actual need the flat to be a 90 corner for lasers and punching.
Hole Command: being able to add different shapes (squares this is from a co-worker) basically like the content center, or access to it threw the hole command.
Transitions: Predefined shapes for things HVAC ducts.
In general just pay some more attention to us in the sheet metal side...
Unfold: Better Unfolding of the parts, with more options (also available solid unfold) as with DataM
Corner Reliefs: More relief options for controlling the corner bends. In some situations you actual need the flat to be a 90 corner for lasers and punching.
Hole Command: being able to add different shapes (squares this is from a co-worker) basically like the content center, or access to it threw the hole command.
Transitions: Predefined shapes for things HVAC ducts.
In general just pay some more attention to us in the sheet metal side...