Going crazy or why beams join non bearing walls?

[A3D]

I'm getting so frustrated... I'm getting this message all the time :

"A structural framing member element is attached to a wall whose Structural Usage is set to Non-bearing" (see enclosed image).

Why on Earth does a structural element have to join a non-structural wall?
The Framing element should only try to join another structural member.

I understand that Revit tries to warn you about a possible user mistake, but it causes more problems than it solves. Example: In 3D structural views I have once again beams that don't touch other structural elements because I have a partition wall above.
It's wrong.

I work with reinforced concrete.

[Alvin_Alejandro]

You can try "disallow Joint"

Select the wall right click the blue dot at the end of the wall near to the beam,,,then disallow joint,

Cheer up........