Is it possible to display different cut patterns for the toposurface?

[hdjohnson]

I'm doing a site plan where I have the existing topo modeled. Now, all I want to do is to get the engineered fill (which is modeled as its own toposurface) to display with a different cut pattern.

Any ideas on how to do this?

[dhurtubise]

If they are different topo, use 2 different materials

[hdjohnson]

Tried that; however, the cut pattern stays the same. The cut pattern for the toposurface is determined under the Site Settings. I don't think there is a way to have two different cut patterns for a toposurface.

[dhurtubise]

Then use a filled region. Not the best way but that should do it.

[hdjohnson]

That was the option I was left with. Just wanted to be able to cut a section at different locations without having to create filled regions for every section cut.

Thanks for your responses.