Moving curtain wall

[Davied2]

Hello once again Ladies and Gentlemen

I have a piece of curtain wall which is embedded within another wall.

The curtain wall mullions are 150 x 50mm and the wall it is embedded into is 400mm wide.

The curtain wall is currently sitting in the middle of the 400mm wall, however, I want to make the curtain wall sit flush with one side of the 400mm wall.

Everytime I select the green centre line of the curtain wall and move it in plan the 400mm wall moves with it.

How can I move just the curtain wall and leave the 400mm wall where it is.

This is driving me mad - Friday afternoon - aaaahhhhgggg.

Calm Thought - best wishes - Dave

[andrewbeadle]

Dave,

Have you tried both detaching the curtain wall from any adjacent walls and also removing any sketches present on the wall - this will probably solve your problem, although you may need to resketch the wall shape after it's move (If the curtain wall is not rectangular).

Cheers

Andy.

[Andre Baros]

When you select the curtain wall to move it, check the unjoin box on the top menu bar. Attached 1

Or, if you have a lot of similar situations, you can leave the green reference line centered in the wall and instead adjust the offset properties of the wall panels and mullions. Attached 2