Room Tags

[mmaxwell]

I keep getting this warning on every Room tag I place in my drawing "Room Tag is not in a properly enclosed region." I have double checked that that the wall properties are room bounding. I have also gone thru and made sure that all of the wall are connected to the floors and roofs. Someone please help.

[aggockel50321]

One possibility:

Go to settings/area settings dialog, and click on the room calculations tab. Check what height the room is calculated at. Chances are it got set outside the range of the wall.

Another:

Go to an elevation view, and check to see where the floor & roof fall in relation to the level of the view where you're trying to place the tag. You may have a base offset of the floor or wall that sets them beyond the range of the tag.

[rod.74246]

Check any columns that fall within walls. They are NOT room bounding and will often stuff up your room boubdaries, particularly when you have the walls ending on the column faces.

[gbrowne]

I would like columns and in-place wall family's to be room bounding, automatically, or am I missing something?

[david.kingham]

I'm having a similar problem except it only applies to my ceiling plans, floor plans enclose fine...walls are 10' high, no base offset...can't figure this one out, looks like I may be calling support today