Corner Windows

[BomberAIA]

How do you create a corner window with only a post at the corner? I know there is a corner glass window posted on RUGI. But I need it w/ a post. Thanks

[Steve_Stafford]

Could you place two windows and a structural post and satisfy your needs?

If not you should be able to create a family using a single window you like and add a second at the angle you are looking for.

Of course I could be completely misunderstanding what you want?

[PeterJ]

I think that if you make your window with a void instead of an opening cut it will let you slide it right to the edge of the wall and beyond, then you only need a standard window, not a corner window, and the post canb be inplace or a column or whatever you choose.

P

[gwnelson]

I accomplished this with windows 90 deg apart with the frames at the center in a common location - the corner. (It was about a month ago, but I'm pretty sure that's what I did).
Good luck.

[jkendsersky]

You can also refer to: The FAQ on how to create a corner window in Revit.
Location: go to the Autodesk Revit home page. Select Support / Support FAQ / Design Bar / Basics / Window / How can a corner window be created?

I have also attached a corner window w/ pole that I created a couple of years ago. It should still work.

I hope this helps.

[beegee]

You can also refer to: The FAQ on how to create a corner window in Revit.
Location: go to the Autodesk Revit home page. Select Support / Support FAQ / Design Bar / Basics / Window / How can a corner window be created?

I have also attached a corner window w/ pole that I created a couple of years ago. It should still work.

I hope this helps.

Joe,

I don't think the link is working ?

beegee

[jkendsersky]

Hmm... I'll have to see why this is not active. I have created a .PDF file with the instructions for now.

[christopher.zoog51272]

Hmm... I'll have to see why this is not active.

Please do, It's been down for a few days now. Thanks!