abs error

[jgray]

I have an abs model of 3d piping and eveytime i open it i get this error that i hav to say ok to lik 100 time then if i pan or zoom it comes back again. ANy ideas......???


Thanks,
john

[Steve_Bennett]

Try a google search for that specific error & see what you get...

[RobertB]

Drawings that cause errors like this really ought to be sent to Autodesk, so they can see what is causing them. Because you are an ABS user, you are on likely on subscription. Use the online support tools to open an incident report, and upload the offending file so the programmers can get to it.

[claus]

I have an abs model of 3d piping and eveytime i open it i get this error that i hav to say ok to lik 100 time then if i pan or zoom it comes back again. ANy ideas......???


Thanks,
john

You have to look into your file structure. I had the same problem, and it was the restructure, that wasn´t 100% right. I´m afraid it´s not a walk in the park getting the hang of the file structure, but i recommend, that you get the hang of the file structure and where to place each content and catalog etc.etc. It will help further on.

Best regards