Rotate Surface Pattern ?

[CHRIS.104410]

Does anyone know how to rotate a surface pattern?. My ceader shingles are clearly upside down. Thanks anyone

[Rhythmick]

If memory serves me correct - use the Tab key to select a line in the pattern, then rotate.

[CHRIS.104410]

You mean in an elevation view? cause that dosen't work there. or do you mean in the edit mode?

[Rhythmick]

It should work in any view that shows the pattern, hoover your curser over the pattern and use the Tab key till a line in the pattern highlights - select and rotate.

[eddy.lermytte]

What type of pattern did you use ? Model or Drafting ?

[CHRIS.104410]

Rotating the wall apears to work in elevation but pattern does not.
That Is, I go throught the rotation command properly after selecting wall and the rotation but nothing changes. it was a standard shingle wall i used.
its model sorry
there seems not to be a shingle patter in drafting for this

[eddy.lermytte]

Try model.

[Rhythmick]

You rotate the model pattern as stated above. - Place the cursor over a line in the pattern and pres the Tab key untill that pattern line highlights (a line in the pattern - not the wall or pattern outline) - select (left click) and rotate.

[CHRIS.104410]

si si si senor it work fine now
thanks a buncho
I was picking the wall and not aware there was a distinction between it and the pattern
thanks both for your patience