Dimensioning

[pwmsmith]

Typically I set dimensions to face of studs or walls, however occasionally I want to go from face to center of wall and back to face. Is ther a hot key or quick override to do this without changing the preference in the status bar?

[aaronrumple]

Typically I set dimensions to face of studs or walls, however occasionally I want to go from face to center of wall and back to face. Is ther a hot key or quick override to do this without changing the preference in the status bar?
Hover over the object and hit tab. This cycles through the available references under the mouse. A basic Revit UI technique.

[pwmsmith]

As many time as I tab to cycle things.......! Should list this under (How could I miss this command).

Red in the face.

Thanks Arron