Pocket Door Worked in 6.0

[d_miyasaki1895]

I am working on multi leaf pocket doors and after creating them in 6.0 and having them work well they no longer do in 6.1 The error message, "Base sketch for extrusion is invalid" pops up.


Thanks,
David

[Charles Francis]

We downloaded the family and used it in 6.1 without a problem. See attached jpeg. We did not see any warning, just the standard upgrade notice.
Charles

[d_miyasaki1895]

Thanks for checking it out! Inserting it works fine, but when you try to flex it it does not work properly, so when you go into the family and try to flex it, it gives the error.

David

[Charles Francis]

David:
Will try flexing tomorrow.
Charles

[beegee]

I had a quick look at the 4dr pocket family and it is faulty.

I havn't yet had time to play around with it to fix it, but i"m suspicious that the reference planes seem to be locked rather than controlled by the width dimension.

[Charles Francis]

dtm:
Had a chance after Beegee's post to look at the door again. Was able to make if flex by editing the panel group at end opposit the pocket. Found that the stile closest to the jamb was not locked to the reference plane. Give the attached modified file a try.
Charles