Tilting a Wall or Sloping a Ceiling?

[aries215]

I am not sure if this is the right place for this but I figure this as good a place as any. I am working on a unique project and we have a unique situation. I need to rotate a ceiling or a wall to 45 degreees. Does anyone know how to override the system to make this happen? We need to make space for MEP to put their information above the ceiling. ANy pointers are greatly appreciated. Thanks in advance.

[Arnel Aguel]

(edit: split thread, moved thread to General)


I am not sure if this is the right place for this but I figure this as good a place as any. I am working on a unique project and we have a unique situation. I need to rotate a ceiling or a wall to 45 degreees. Does anyone know how to override the system to make this happen? We need to make space for MEP to put their information above the ceiling. ANy pointers are greatly appreciated. Thanks in advance.You should post your topic under general that's the right place for your question and definitely you will get a lot of rensponses.

To rotate the ceiling and I'm assuming you want an incline ceiling use the slope arrow tool. As for the incline wall you can create an in place extrusion wall or an incline wall from blended mass then convert into wall by face.

Hope this helps.