Stress Analysis

[bweir]

What does this message mean (see attachment msg.png)?

It occurs when I try to run a stress analysis on a sample assembly file analyze-3.iam. I am using Steel as the material. Apply a Fixed Constraint to the bottom two faces shown (see attachment fixedconst.png). Apply a Pressure to the three inside faces (see attachment pressure.png). When I start the stress analysis it will run for a little bit and then the message pops up. How can this be fixed?

[jonathan.landeros]

What does this message mean (see attachment msg.png)?

It occurs when I try to run a stress analysis on a sample assembly file analyze-3.iam. I am using Steel as the material. Apply a Fixed Constraint to the bottom two faces shown (see attachment fixedconst.png). Apply a Pressure to the three inside faces (see attachment pressure.png). When I start the stress analysis it will run for a little bit and then the message pops up. How can this be fixed?I'm not exactly sure. It's a little cryptic, or maybe I'm just not much of a stress analysis guy.

Just a wild guess on my part, but have you tried changing the loads, or maybe the mesh size? I wonder if it's just some strange 'sour spot' where the analyizer freask out.