Two storey Farm House

[barathd]

I am presently doing a small addition and renovation to an existing farm house. Everything seem to be fine (with the exception of the exterior step issue). I have managed to nicely delineate between the existing and new construction at the main floor level. However I have tried to do the same on the second level - existing walls do not want to grey out (half-tone) when I refer to them as existing. Why - existing walls can not be on multiple levels ???

Regards

Dick Barath

[sjsl]

Check your phasing filter on the second floor and see if it is the same as the first floor.

[patricks]

Make sure the Phase is set to New Construction, and the Filter is set to Show Previous + New in the 2nd floor's view properties.

I typically find that my floor plan views will default to Show All when I create them, which does not apply the phasing graphic overrides, which will not show existing walls as gray. I usually have to change them to Show Previous + New to get them to show correctly.

[barathd]

Make sure the Phase is set to New Construction, and the Filter is set to Show Previous + New in the 2nd floor's view properties.

I typically find that my floor plan views will default to Show All when I create them, which does not apply the phasing graphic overrides, which will not show existing walls as gray. I usually have to change them to Show Previous + New to get them to show correctly.


Right on - works great.

Thanks much.

Regards