Facia

[philipnoland]

Is there any way to solve this problem? I have a built up facia on a Plumb cut roof. At the corner where two pieces join there is a cut. Geometriclly speaking it is impossible to build what I am looking for without using to different sized facias.

[aggockel50321]

Try this.

Highlite the facia on the gable end. A blue dot (grip) will show where the gable facia joins the eve facia. Grab the blue dot & pull the end of the gable facia past the eve facia. That will stop the join & resultant cut you are getting.

hth

[philipnoland]

That deffinitly stops the join & unwanted cut. But, still its not what I am looking for. When I stopped the join it seems as if I now need a facia that will match the height of the end cut.

Do you know what I mean?

Does this mean that there needs to be two different sized facia's that join. If so, can you join two different facia's?


Philip

[aggockel50321]

Yes, if you want an even join, you'll need two different size facias, and yes, they should join.

[philipnoland]

What do you do to get them to join?