eckdahlrd
2006-02-28, 09:16 PM
Okay, so I've got sections every 100' along an alignment. Most of which look fine, but there is one section that is using a datum of -30'. Any ideas why out of 96 section views only one would turn out like this?
I checked the elements that are shown in the section view, and not a single one is below 1300'. I don't know what else would force it to go so low with the datum.
Stumped!
Robert
I checked the elements that are shown in the section view, and not a single one is below 1300'. I don't know what else would force it to go so low with the datum.
Stumped!
Robert