Road in Site

[Mark Vorstenbosch]

Hey Reviteers


Hope that any one has a answer form on this one.
I have a site that falls quite a bit and need to put a road in that cuts in to the site and runs up at an angle.I don't what to use split surface because the it follows the site contours.

How will I get this right.

[aliya14]

Why don't you try using a subregoin and then use a graded region to have a flat road

Regards,

Aliya

[Mark Vorstenbosch]

Yes why didn't I think of that.
It's been a long week.

I'l try that thanks.