cparsons
2006-03-13, 10:41 PM
Hi all,
We're getting ready to lasercut our first Revit model. Does anyone have any advice / guidelines on doing this? We're going to make a 1/16" study model (and as one would hope) set up a process that would allow us to produce a model at least every two weeks.
Thanks,
Chris
We're getting ready to lasercut our first Revit model. Does anyone have any advice / guidelines on doing this? We're going to make a 1/16" study model (and as one would hope) set up a process that would allow us to produce a model at least every two weeks.
Thanks,
Chris