new and existing grading

[Justin Marchiel]

Is there a way to show 2 different fill patterns between new and existing grading? It seems to me that the site setting dialogue box only allows 1 type of fill pattern for section cuts regardless of phase, etc.

I guess i could use a filled region, but i was hoping that my toposurfaces could handle it for me.

While i am hear i would also like to know if there is a way to have the exsting "demolished" contours to show even if the new coutors may overlap them. this way i can give some sort of reference to where the exsting site was compared to the new.

Thanks

Justin

[sbrown]

If you are talking about sections, then you are correct, you only get one cut fill pattern.

[Justin Marchiel]

Seem i am stuck with the fill pattern.

any comments about the contour lines?

Justin