Footing visibility in sections/elev's

[BillyGrey]

Hi all,

I am modelling a stick frame residence now, and am using "walls"
for my concrete footings. I want to be able to turn off the visibility of "walls" below FF, but not everything.
Is there a way to isolate the visibility of in place family footing-walls without resorting to crop regions or white fills, while leaving my stud
walls on in a section or elevation?

Revit's visibility settings appear to me to lump all "walls" into one
on-or-off catagory...(They want to be real footings, not walls, ney?) :shock:

Thanks for any advise.

BillyG

[aaronrumple]

The best way is to put in the toposurface around the building...

[jwilhelm]

I believe you could make a phase called footings, then set those footings to that phase then have that footing phase not show up when you dont want to see them