Using 3DClip command in AutoCAD 2004

[portdor]

Using AutoCAD 2004 and the 3dclip command, the clip window does not show the model and always hides the model compleatly when the back clip is on. When I try to move the back clip the front clip line disapears and I can not get it back. I have used 2005 in the past and had no trouble with this. Is there a secreat to using it with 2004?

[Mike.Perry]

Hi

Using the exact same drawing file, do you experience the above issue / problem in AutoCAD 2005 or is it only an issue / problem in AutoCAD 2004 ?

Have a good one, Mike

[portdor]

I used AutoCAD 2005 at a different company so I don't know if these files would react differently on 2005.

[Mike.Perry]

Hi

Is it possible to post an example drawing file; them someone here can test the file in AutoCAD 2005 or 2006 for you.

Have a good one, Mike

[portdor]

Here is a zipped etransmit of one of the files, if anyone can figre this out I would be gratful.

[jimmy.bergmark]

I don't have 2004 installed but when I tried it in AutoCAD 2007 I had no problem with the clipping except that all but the bottom left view I had to move the back plane because it was infront of the model.

[Mike.Perry]

I don't have 2004 installed but when I tried it in AutoCAD 2007 I had no problem with the clipping except that all but the bottom left view I had to move the back plane because it was infront of the model.Hi

Same results as Jimmy, using AutoCAD 2005.

Have a good one, Mike

[portdor]

Looks like I'm stuck with the bad clip controls until Bentley/Rebus gets around to updating their software to work with the updated versions of AutoCAD (I also miss the text editor and the "between two points")