Toposurface point elevations

[patricks]

When editing a toposurface, it seems as though the elevations shown for each individual point always reference the project elevation of 0. So even if you have relocated your project up to some height above sea level, you still have to input point elevations relative to your 0 floor level. The only way to make the points display elevation above sea level is to move all levels and model geometry up to whatever height above sea level the finished floors are.

Am I correct on this?

Also it is impossible to have toposurface points display a shared elevation, while having the floor levels display project elevation. Yes?

Someone please confirm so I don't keep running around in circles trying to figure out a way to make it work the way I think it *should* work. Inputting points at -2' - 6" or -1' - 6" because my finished floor is between even contour elevations is a real pain.

[anthony.67953]

We lock all levels with dimensions and raise finish floor elevation to proper height such as (128.75').