Worksets Issue - Visibility and Linework

[Steve_Stafford]

If you use the linework tool, for example, to add overhead lines to a floor plan for a major ceiling feature...Beware!

Turning off the workset that contains the linework adjusted objects in Visibility Graphics will undo your work. This is an acknowledged defect. When you turn the workset back on the linework will be "gone".

Make sure you don't turn off the workset that these lines are part of or use detail or model lines instead for now.

Using Build: 20030502_2019

[Wes Macaulay]

I assume this applies only to objects in plans that are "lineworked" in from RCPs... this doesn't apply to other view types does it? Could be nasty, otherwise...

[Steve_Stafford]

That I can't say, I did encounter it with the plan/RCP scenario but I haven't done much else that I would have turned off the workset like I was with my RCP workset. I hope it doesn't spread to other situations either.