Slanted walls

[Jit]

Hi All

I am trying to model slanted walls, any tips i.e. do I have to model them or can I use standard walls ?

Thanks in Advance

[davidwlight]

Jit, I would normally model them inplace, using an inplace family. However, it depends if you wall is a butressing wall, if it is, you could add a profile to the wall to form the slope.

[hand471037]

I usually do this using Blends. But Sweeps are good too. Just make certain that you put the in-place family into the 'wall' catagory. Then you'll be able to drop in doors and windows when in an elevation view. Try it, it's way fun. ;)

[Jit]

Thanks guys