Imperial tool palettes unable to execute

[wmmccully]

Has anyone run into this problem before.

Uable to execute the tool. Possible causes are:

The tool is not registered properly. Please check your installation.
The tool is from another application and is incompatible with current application.

This popped up when I tried to attach a basic lane to an assembly point.

Any ideas would be helpful. Running 3d with sp1+2 and HF2

[dmarx]

my suggestion is to insert the installation disk and run the fix utility....

[MHultgren]

I would probably check to see which version of the XML parser you have installed.

[Scott_Haynes]

This original post is obviously not for 2010 C3D.
But, I can't seem to get ANY of my Imperial or Metric Tool Palettes to show up.
Any ideas?

[mjfarrell]

close c3d
change your screen resolution
open c3d
open tool palette


IF

it does not open press F2 and report back what is happening on the command line