View Full Version : Wall Section Modification
I have noticed in V9 that when I try to modify the wall section, in this case, unlocking the assembly so I can detail it, the locks do not display. If I hover near where I think they are supposed to be I can lock and unlock but then the lock goes invisible again.
mbalsom
2006-04-21, 12:04 AM
Same problem here. Locks seem very "sticky"
David Haynes
2006-04-21, 12:38 AM
The locks have been a 'sticking' point for a long time.
What I understand is that the lock appears near the center of the modeling element. If you are working on a section of a building and you are trying to lock the floor (for example), the lock may be far away from where you are working. This is due to the fact the floor element is quite big and the center of the floor is a good distance from where you tried to find the lock. It takes a little practice on this one, and it can be frustrating.
Hope this helps.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.