Express Tools command Layiso causes - bad argument type: lentityp nil

[alexpapadias]

Hi everyone,
this is the first time I enter the forum, and this is the reason why....
When I attach any xrefs from a specific client in Germany, the layiso command
stops working and I get this message> bad argument type: lentityp nil
When I detach the xref the system goes back to normal...anyone have any ideas?
Thanx
alex

[rkmcswain]

Hi everyone,
this is the first time I enter the forum, and this is the reason why....
When I attach any xrefs from a specific client in Germany, the layiso command
stops working and I get this message> bad argument type: lentityp nil
When I detach the xref the system goes back to normal...anyone have any ideas?
Thanx
alex

What AutoCAD version?

If 2006 or earlier, what happens if you run the EXPRESSTOOLS command when the LAYISO command isn't working? Does it restore the command? Do you get other errors?

[Mike.Perry]

When I attach any xrefs from a specific client in Germany, the layiso command
stops working and I get this message> bad argument type: lentityp nil
When I detach the xref the system goes back to normal...anyone have any ideas?Hi

Maybe...

ID: TS74675 - Error in Express Tools: lentityp nil (http://usa.autodesk.com/adsk/servlet/ps/item?siteID=123112&id=2893360&linkID=2475323)

Have a good one, Mike

[Mike.Perry]

Hi

Plus the following might help...

Express Tools/Layer isolate problem

Have a good one, Mike

[alexpapadias]

Hi rkmcswain,
well, its on Autocad 2004
I tried the express tools command but stil doesn't do the trick... Only cure I've found so far is detaching the xref....then everything gets back to normal

thanx anyway...

[rkmcswain]

Hi rkmcswain,
well, its on Autocad 2004
I tried the express tools command but stil doesn't do the trick... Only cure I've found so far is detaching the xref....then everything gets back to normal

thanx anyway...

Did you look at http://support.autodesk.com/getdoc.asp?ID=TS74675 as suggested?