Callout or Detail Titles

[Rudy Tovar]

I have a detail area only 5 inches wide (forget about height), but my title falls outside that area width...

My question is...How can you move the Title over or condense the distance, and maintain the numbering and scale in the same location...?

Example (dot or periods are added because this site may remove the extra spaces)
Revit...

A Detail Title..................Scale: 1/4"=1'-0" 1

Desired....
A Detail Title Scale: 1/4"=1'-0" 1

[christo4robin]

RT,

1st, can you simply shorten your detail title? Note that you can have a different title on the drawing sheet than the title in the project browser if you choose - check view properties under Identity Data.

2nd, you can create a new View Title and use apply a width factor to the label text. Go to properties for the label and then adjust as required.

[Rudy Tovar]

That did the trick...Thank you...

Got to remember that just about everything is handled by components or families...

So I created differing view titles for single and double detail boxes...

Worked out great...