Another wall joining problem

[blumarble]

I wasn't able to find this particular problem, and maybe there isn't a solution yet...
I can get one or the other interior walls to meet the inside corner of the exterior walls by pulling both away then back. The first is OK, the second has a gap.
Is there a solution? Thanks!

[patricks]

Pull back one or both interior walls, right click the blue handle and say Disallow Join, then extend both of them into the exterior walls and do join geometry.

[blumarble]

OK, I had to turn off all wrapping of the finish layers or I still got a gap. The gyp in the corners still isn't quite right, but close enough. I saw another thread that seemed to draw the conclusion that this may happen in some cases, and there really isn't a fix for it(?).

[Wes Macaulay]

You need to join geometry between the two interior walls as well.