stafford.cad
2004-06-02, 11:42 PM
If anyone can help me with double lines I have never been able to get them snap to an object that I desired
Is it possible why not of what use are they otherwise
Mike.Perry
2004-06-03, 07:01 AM
Hi stafford.cad
Please note I've *moved* this Topic (Thread) from the Forum feedback (http://forums.augi.com/forumdisplay.php?f=49) to this one as I believe it would be better served here.
Thanks, Mike
Forum Moderator
************
Hi
Are you referring to MultiLines (MLine) and using them with SnapAng?
If yes, you're out of luck. My bad, SnapAng with MultiLines does work, it helps if I actually turn on SnapMode instead of just setting SnapAng (you can tell I don't normally use SnapAng & SnapMode).
Instead take a look at using Polar Tracking in conduction with PolarAng.
Within the old Forums there was a good discussion on the use of MultiLines and their limitations; if I remember correctly there were a few very good Wish List Items made that would greatly improve their functionality + actually make them a useful Object Type within AutoCAD.
You might want to head over to the ACAD 2005 Wish List Forum (http://forums.augi.com/forumdisplay.php?f=57) and get the bal rolling again on MultiLines.
Personally, if Autodesk don't improve MultiLines drastically they might as well remove them from their product.
Have a good one, Mike
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.