direction of surfaces

[ibn_seeena]

Hi
when I make surface by any method like cross section and rail, the result is surface which it has normal line, my question is : can I change direction of that surface? if it has direction to up , can I change it to down?
thank you for your help

[jonathan.landeros]

Hi
when I make surface by any method like cross section and rail, the result is surface which it has normal line, my question is : can I change direction of that surface? if it has direction to up , can I change it to down?
thank you for your helpOld skewl question. It's been a long time since I've messed with MDT surfaces (and I wasn't that good then). I don't have MDT right in front of me, but if I remember right I think you can edit the surface and 'Flip Normal'.

You might be able to search the help system for 'Flip Normal' too.

Hope this helps

[ibn_seeena]

thank you jonathan I tried in : surface , edit surface, then ajust normals.
thank you very much indeed

[gparange]

Hi there,
If possible can you tell me what is the "Truncate" option in "ameditsf" or edit surface dialog box. I read through HELP but i was not able to understand it :(

pleeaaaaase

Ganesh