Import/ Export settings

[jaroguy]

In the Import/ Export settings dialog box I find it very difficult to figure out which category to go to when specify a layer name to export to. I want the toilet partitions to export to the A-FLOR-TPTN layer. So which category do I change? I would think there would be a category for toilet partitions', why not, there is everything else under the sun for a category!
So I went to 'Specialty Equipment', and changed the projection layer name to A-FLOR-TPTN. Great it worked, but it also change a lot of other thing to that layer. Back to the drawing board.

I guess the question is: How can I specify a specific category for the toilet partitions so I can go to the Import/ Export dialog and get just the toilet partitions to export to the correct layer.

Thanks in advance for any suggestions.

Jay

[dhurtubise]

Go into your toilet partitions family, set all the needed object to a sub-category of specialty equipment.
Then when you export you will see that category under the export DB, set it to whatever layer your want

[jaroguy]

Still doesn't work the way I wanted it to. I went into the toilet partition family and set all objects to the toilet partition sub-category of specialty equipment. After exporting the partitions are now a block on the E-EQIIP layer (the layer the main specialty equipment category should export to). But when I explode the block the lines are on A-FLOR-TPTN. Is this what I should expect or can I get the block to export on A-FLOR-TPTN?