View Range?

[ford347]

I have never been the best with using the view range....I just usually get it to work....in this case however I am stumped. I have a structural view in which I have set my top offset, my cutplane to 0. The bottom range and the view depth have a value, which is ok. I have an underlay of the level below as well. The trusses above are still showing up in the view, which I cannot have. The only thing I can think of is the tail to the trusses, but the whole truss is showing up, not just the tails??? Any suggestions.

I have also tried applying a filter, but for some reason, I can't get my new project parameter to show up in the filter list under filters, but it is in the structural framing families, etc.???

[ajayholland]

With certain family types, the entire object is displayed if any part intersects the cut plane. Turn off the plan view visibility in the family; substitute symbolic lines with subcategories to control the visibility in specific views.

~AJH

[ford347]

Thanks! I'll give it a go!