dgreen.49364
2006-08-03, 05:54 PM
We use a lot of drop down soffit ceiling construction, with lay-in ceiling butting up against it. Pretty standard stuff. These soffits consist of gyp board over metal stud framing, on the sides and the bottom. The gyp board should wrap around the ends of the framing. However, I am having trouble figuring out how to make this look right in section. I'm not sure if it is an issue of wrapping correctly or what. I am including two pdf files. The one called Wrong is how I am getting it to look with Revit. The one called Right is how it SHOULD look. Can anybody tell me what the trick is?
Thanks.
Thanks.