tschaars
2004-06-09, 09:22 AM
Situation:
We use ISO-format paper A0; A1; A2; A3 and A4.
All margins set to 0mm.
All sizes assigned to the 36" roll used by the plotter.
Configuration:
AutoCAD 2004 (this problem exists since AutoCAD 2000)
HP750C 36" plotter
Non-System Driver - Hewlett-Packard DesignJet 750C C3196A
hpgl28.hdi version 1.1.8.0.16.86 (U5-1)
Problem:
The cutting border at the edge of the paper-layout will only plot one long and one short border.
While there are no warnings, the plot exceeds maximum.
(the plotter dialogue-box "partial preview" sometimes says: "plotting area exceeds maximum".
I cannot tell excactly when the messages is there and when it's not)
question:
Why are the opposite borders not plotted?
due to AutoCAD or caused by the plotterdriver?
I suppose that the problem is caused by converting milimeters to inches.
(AutoCAD basically calculates inches?)
our solution:
We now use custom paper sizes +/+ 1mm:
Iso A0 1189x841mm -> Custom paper A0 1190x842mm.
Iso A1 841x594mm -> Custom paper A1 842x595mm.
Iso A2 594x420mm -> Custom paper A2 595x421mm.
Iso A3 420x210mm -> Custom paper A3 421x211mm.
and the entire border appears on the plot!
We use ISO-format paper A0; A1; A2; A3 and A4.
All margins set to 0mm.
All sizes assigned to the 36" roll used by the plotter.
Configuration:
AutoCAD 2004 (this problem exists since AutoCAD 2000)
HP750C 36" plotter
Non-System Driver - Hewlett-Packard DesignJet 750C C3196A
hpgl28.hdi version 1.1.8.0.16.86 (U5-1)
Problem:
The cutting border at the edge of the paper-layout will only plot one long and one short border.
While there are no warnings, the plot exceeds maximum.
(the plotter dialogue-box "partial preview" sometimes says: "plotting area exceeds maximum".
I cannot tell excactly when the messages is there and when it's not)
question:
Why are the opposite borders not plotted?
due to AutoCAD or caused by the plotterdriver?
I suppose that the problem is caused by converting milimeters to inches.
(AutoCAD basically calculates inches?)
our solution:
We now use custom paper sizes +/+ 1mm:
Iso A0 1189x841mm -> Custom paper A0 1190x842mm.
Iso A1 841x594mm -> Custom paper A1 842x595mm.
Iso A2 594x420mm -> Custom paper A2 595x421mm.
Iso A3 420x210mm -> Custom paper A3 421x211mm.
and the entire border appears on the plot!