2005 Plot Problem / End Program

[markm.66285]

Suddenly, when I try to plot a drawing in AutoCAD 2005 will immediately quit and send me back to the desktop! Never had a problem until just now. I tried cleaning and defraging the hard drive, restarted the PC twice and still no luck. All other programs print just fine.
Anyone with any suggestions would be most helpful.

Thanks,

Mark

[Mike.Perry]

Hi

Check out the following Technical Document on the Autodesk web site under the Knowledge Base section -

ID: TS72456 - Error: Unhandled Access Violation Writing 0x36082ffh exception at levb3a0h (http://usa.autodesk.com/adsk/servlet/ps/item?siteID=123112&id=2891991&linkID=2475323)

Have a good one, Mike

[markm.66285]

Thanks Mike! I will check out that link...... by the way I wrestled with the problem for about an hour, then I just uninstalled the program and reinstalled the program. So far things are working fine. I was immediately able to print my drawing on both my large H/P 450C and on my small Dell 940 printer. Yeah!


Thanks again,

Mark

[Mike.Perry]

by the way I wrestled with the problem for about an hour, then I just uninstalled the program and reinstalled the program.
Hi

That's basically what the Technical Document recommended; fingers crossed it solves the issue/problem.

Have a good one, Mike