Solid Vrs Void

[stuntmonkee]

I have run into this problem several times, and I always seem to catch it after I'm a few hours post it.

What happens is I create a small "model/in place family" in a project. Often I have used voids. Then i have to mirror it. . .either to copy it, or to adjust or whatever. Looks fine! That is untill you edit it again. Then it takes just the voids and throws them in wacked out locations. Solids always stay in the intended spot. Not always a real complicated fix, but it just is annoying. Anyone else get this?

not a big deal, just asking. . .

Stunts

[adegnan]

I get that with some of the plumbing fixtures. I think some of the 3-d fixtures (showers & tubs) were imported into Revit from some other system... stuff I got off of RUGI a LONG time ago and just continue to upgrade... kohler stuff and when I mirror them I have problems with the geometry not being the same location that the 2D linework is.