Precast Cornice sweep

[boofredlay]

I have searched here and came up with nothing.

I have loaded the Precast Cornice Profile into my project. However when I go to do a host sweep, it does not show up. Please help!

Thanks.

[boofredlay]

Actually, instead of using the standard pre-cast sweep I would like to make a cornice more like the attached pic. Created in SketchUp.

I looked all over the help section and all it says is to load a profile and select it when you sweep... it is not there.

I fear if I follow the directions as how to make my own profile family, it won't show up either.

[rodneyf]

I think there is one small step missing. After you go to host sweep and before you place any sweep you need to select the properties button on the option bar and then click edit/new button the select duplicate button then type the name of the sweep to whatever you want then select from the drop down list of profiles and you should see the profile you loaded and then select it then click ok all the way out and now you should be creating sweeps with the profile you wanted. Hope that helps.

[boofredlay]

Well there it is...

Thanks Rodney.