Lines in plan with walls?

[CADMama]

Is it possible to do a line - graphic line - down the middle of a wall in plan view?
I am attaching a pic.
Donnia

[Tom Dorner]

Check out this thread and the links within it.

http://forums.augi.com/showthread.php?t=4554&highlight=fire+tape

Short answer is not yet.

[CADMama]

Check out this thread and the links within it.

http://forums.augi.com/showthread.php?t=4554&highlight=fire+tape

Short answer is not yet.Hey Thanks Tom dear. This helps a ton. I had already thought of fill patterns. I will get the company I am setting up to help decide this tomorrow. For now - I think I am siging out. It has been a long week with my first customer getting their first project started and another customer getting the custom stuff set up. I am looking forward to the weekend and NO REVIT!

[sbrown]

You will need to use a detail line for it to show on top of the wall, since model lines are drawn on a plane they would get drawn on the floor and then hidden by the wall.

[CADMama]

You will need to use a detail line for it to show on top of the wall, since model lines are drawn on a plane they would get drawn on the floor and then hidden by the wall.
So - can the line be part of the wall or do you have to draw it on each wall?
If it can be part of the wall - how do I do that one?

[Elmo]

You would have to draw it individually if it was a detail line CADmama.

[CADMama]

You know that is not what I wanted to hear.

There should be a fill pattern that is a single line and you could change the linetype when you needed to.

OK - dreaming over - back to work.

Thanks dear,
CADMama