Filled Region Anomaly

[dbaldacchino]

I have been noticing this.....in a detail component, the same hatch is represented at half the scale that it is represented in a filled region (or the filled region hatch is double the size of the same hatch in a detail component). Take a look at the attached file.....anyone else noticed this?

[david.kingham]

Not sure, but if you reload the detail component it takes on the pattern from the project.....

[dbaldacchino]

Not sure I'm understanding your point, but the detail component in the attached file uses a 1/8" diagonal hatch (the standard masonry hatch). When placed in a project (also has a 1/8" diagonal hatch), the hatch comes in twice the size of what it should be. See the hatched region using the same 1/8" diagonal hatch in the attached example file; it's half the size of the hatch in the detail component.

EDIT: My apologies, it's the other way round....the hatch in the detail component comes in HALF the size of what it is in a filled region within the project.

[david.kingham]

Ok I figured out what i did....Open the family, change anything...scale, detail level, doesn't matter, then reload it and it will be fixed

[dbaldacchino]

Hmmmm that was bizarre. Thanks for looking into it. I guess you could conside this as a partial bug :)