sfraney
2006-09-18, 05:13 PM
Hello everyone.
I noticed that Revit's brick materials have a feature under the "edit / map tab" called "Procedural Bumps". I assume that this is for bump mapping, would this be correct? If so, how can I enable the bump feature so when a brick veneer is rendered it gives the "bump" effect. Help on this would be much appreciated.
I noticed that Revit's brick materials have a feature under the "edit / map tab" called "Procedural Bumps". I assume that this is for bump mapping, would this be correct? If so, how can I enable the bump feature so when a brick veneer is rendered it gives the "bump" effect. Help on this would be much appreciated.