Exporting to autocad RCP, lights off set 3"

[Don Sutherland]

When I export a Revit Reflected ceiling plan to Autoocad the lights are off setting approx 3" from the grid lines to the left side in the autocad file. Also the Blue outline at the gid / lights are also off setting the same distance. Any ideals to fix this problem??

[sleimgruber06]

Possibly move the lights in the .dwg over 3" to counterbalance the 3" offset.

[Don Sutherland]

I move the lights, it is a big job when you have a lot of lights, the mechanical registers showed up ok. It would be good to have a good solution.
Looks like the SCRUG was canceled.

thanks

[sleimgruber06]

yes, this weeks SCRUG meeting has been postponed, but there is talk of next thursday...

[sleimgruber06]

Could your .dwg be off center? instead of located at x0,y0 on center with the .rvt file?