avn
2006-09-22, 04:42 PM
I have a short "L" shaped alignment and pipe network. The profile, and the long leg, (Sta 0+50 - 3+00) are correct, but when I add pipes to profile view, the structure @ 0+00 and the pipe from 0+00 to 0+50 is shown as if you were looking at the long side in profile.
Instead of adding the SSMH +/-1" left of 0+50 at 0+00 of the profile, it comes in a little to the right, how it would be looking at it from the side.
Instead of adding the SSMH +/-1" left of 0+50 at 0+00 of the profile, it comes in a little to the right, how it would be looking at it from the side.