PDA

View Full Version : CAD Standards Checker - Layer Translate (laytrans)


jrebennack
2006-09-25, 08:16 PM
When saving Layer Translate settings, it allows you to "save" the settings as a *.DWS file. If I then attach said *.DWS file to a drawing, will the translation take place automatically when you run CAD Standards checker?

If not, how could I get a layer to translate automatically?
Opie
2006-09-25, 09:03 PM
When saving Layer Translate settings, it allows you to "save" the settings as a *.DWS file. If I then attach said *.DWS file to a drawing, will the translation take place automatically when you run CAD Standards checker?

If not, how could I get a layer to translate automatically?
I think so, but I haven't run the tool often enough to figure that out.