rjcrowther
2006-09-30, 03:20 AM
I would like to make a spot elevation that gives the height above a reference in building module units rather then metric (or imperial) measurement.
My particular instance is to indicate window sill and head heights in brick courses and not mm. So, when I place a spot elevation on a window head at 2143mm high I would like it to indicate 25c.
Can this be done?
Thanks,
Rob
My particular instance is to indicate window sill and head heights in brick courses and not mm. So, when I place a spot elevation on a window head at 2143mm high I would like it to indicate 25c.
Can this be done?
Thanks,
Rob