SCShell
2006-10-01, 03:29 PM
Hey there,
Has anyone else experienced this one. It started in 8.1 and has not been fixed yet.
Every outlet and 4-plex doesn't show the actural circle in an exported DWG. The lines are there however. I also don't own ACAD, so maybe it is just my DWG viewer.
Just curious.
Thanks in advance
Steve
Has anyone else experienced this one. It started in 8.1 and has not been fixed yet.
Every outlet and 4-plex doesn't show the actural circle in an exported DWG. The lines are there however. I also don't own ACAD, so maybe it is just my DWG viewer.
Just curious.
Thanks in advance
Steve